P20 PLUS HIGH GLOSS POLISH

Product detailed description

Medium-abrasive high-gloss polish for effective paint treatment.
Specially adapted aluminum oxide powder consistency

Moderate abrasion and very high gloss level
Easily removes sanding marks from P2000 grit
Thick consistency

The polish does not splash
Cost-effective
A little dustiness
No strenuous cleaning of adjacent surfaces
It can be applied manually and by machine

For common and abrasion-resistant types of varnishes

Suitable for use on old and new lacquered surfaces

Does not contain silicone

Warning
Due to its chemical composition, this polish is safe when used as directed.

In the interest of achieving optimal surface quality without micro-scratches, High-Gloss Polish Plus must not be combined with other polishes or solvents. Failure to follow these instructions will void the warranty.

At a temperature of 15-25°C, the original containers can be stored for 24 months. Protect containers from frost and direct sunlight during storage and transport.

The instructions for use are recommendations based on the tests we have performed and our experience. Do your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any responsibility for the outcome of a particular application.

Area of ​​use
Medium-abrasive high-gloss polish for the effective treatment of paintwork, sanding marks and scratches on old paintwork, as well as for removing imperfect surfaces on dried topcoats during repairs. Preparation for painting: Sanding marks and scratches, renovation of used vehicles. Lacquered surfaces in the automotive, marine or wood industry. (solvent-based paints, single-component and multi-component systems, water-based paints, powder coatings, colorless scratch-resistant varnishes). It is not suitable for matte varnishes.

Instructions
Shake well before use. Moisten the surface of the polishing wheel evenly with the paste and apply a small amount to the surface to be polished. Place the polishing disc directly on the polished area and start the machine. Apply adequate pressure at 1500-2000 rpm. Polish the surface until sanding marks or paint imperfections are removed. Work in parts! Remove the remains of the polish with a microfiber cloth.